Integrated Circuit and Cleanroom Swab

Usually, we use a brush to clean the IC with cleaning solutions, this is definitely a good method for the IC cleaning as a special washer water or thinner is not conductive. It is very important, as thus will not damage the electronic components. There also some more advantages like easy to evaporate, easy to dry after washing. This method is widely used in the electronics industry or electronics repair shop, product development department for its features of simple and convenient.

Circuit board cleaning brush, previously mostly use cotton bud. The cost of this kind of swab is very low, as they can produced in large quantities. Besides, they meet the IC board for anti-static requirements. But there is a problem, Hooking wire. Because the swab head is wrapped by cotton. When you use them to wipe the board, are particularly vulnerable to the projections hooked and stay on the board panel, thus produce incalculable damage for the life of the plate. Not to mention wood and paper handle are easy to bend and fracture, a very large impact on efficiency.

In fact, except the normal cotton bud, there is another very good tool for the IC broad cleaning. That is cleanroom swab. Meditech Technology Co., Ltd is direct factory manufacturing high quality cleanroom swab, we do have such kinds of cleanroom swab for IC broad cleaning. We use 100 PPI polyurethane foam and polyester fabric as head materials, to ensure good cleaning performance and eliminate snagging phenomenon. For swab handle, we use polypropylene to make it light and resilient, no fiber shedding and abrasion resistant with good solvent compatibility. It is the most important change on swab features. Meditech foam swab FS750, a tip head swab, is specially made to clean small, slotted and recessed areas in IC board.